Barrel Spares  There are 29 products.

Barrel spares for the home brewer

Everything the home brewer needs as a spare for use with home brewing barrels.

per page

Barrel Cap 2"  & Pin Valve 2" Barrel Cap Complete with BRASS PIN VALVE to fit the basic barrel. This cap takes the small 8gram gas bulbs. Ideal for use with the Co2 Bulbs and bulb holder purchased separately.

£ 12.99
0 Review(s)

4" Barrel cap complete with Stainless Steel S30 valve 4" cap fitted with a (STAINLESS STEEL S30 VALVE) combined pressure relief and CO2 injection valve which uses the large S30 refillable CO2 cylinder for home brewing. These caps are supplied either as a black or green cap depending what the manufacturers have in stock

£ 12.99
0 Review(s)

Barrel Cap 2” with a hole for home brewing These are 2-inch barrel caps with a pre-cut hole to accommodate CO2 valves. The caps fit the standard barrels with a 2-inch neck. They can also be adapted to use as pressure kegs for a home bar.

£ 3.50
0 Review(s)

2" Barrel cap (Brass S30 valve) 2" cap fitted with a (BRASS S30 VALVE) combined pressure relief and CO2 injection valve which uses the large S30 refillable CO2 cylinder for home brewing. 

£ 10.79
0 Review(s)

2" Barrel Cap complete with STAINLESS STEEL PIN VALVE to fit the basic barrel. This cap takes the small 8gram gas bulbs. Ideal for use with the Co2 Bulbs and bulb holder purchased separately.

£ 10.79
0 Review(s)

4" cap fitted with a (BRASS S30 VALVE) combined pressure relief and CO2 injection valve which uses the large S30 refillable CO2 cylinder for home brewing. These caps are supplied either as a black or green cap depending what the manufacturers have in stock

£ 12.99
0 Review(s)

Cap Spanner for King Kegs 4 inch A handy device for screwing up and loosening off your 4" vent cap which fits the King Keg barrelUsing this spanner provides the extra leverage that is often required to open a king keg.

£ 2.95
0 Review(s)

King Keg cap 4 inch A king Keg 4-inch cap with a hole for the valve and an O ring.

£ 3.95
0 Review(s)

King Keg 4" cap & S30 gas valve S30 valve Brass/Stainless Steel Used with S30 CO2 gas cylinders Spare washers, rubbers and 'O' ring available separatelyDoes not have a centre pin in valveNote this fitting is not suitable for use with sparklet gas bulbs

£ 14.50
0 Review(s)

Back nut for homebrew taps Black Plastic Backnut for Drum, Quickserve and Fermenter TapsThis backnut is a replacement nut that fits most of the homebrew taps

£ 0.90
0 Review(s)

S30 Bulb Holder With Steel Thread For 8g CO2 Bulbs-sparklets type An ideal solution to what was once a problem- insert a stainless steel thread to the inside of the plastic C02 gas bulb holder for more stability. This gas bulb holder works with all genuine Hambleton Bard S30 pin valves.Pin Valves are for use with the 8 gram(sparklets type)gas bulbs not to...

£ 3.49
0 Review(s)

King Keg Float for home brewing These are the new floats for King Kegs.  They are better designed than the old floats, being smaller, more adaptable and easier to connect to the back of the tap.

£ 3.99
0 Review(s)
Showing 1 - 12 of 29 items